How do I know when I’m getting Far Infrared?
The BioMat controls work similar to a thermostat with the far infrared / heat alternating with the negative ions. While the BioMat is in heating mode, you are getting the far infrared and heat. Once the BioMat has achieved its set point temperature, it will switch to Negative Ion emission. The two settings then alternate just as a thermostat alternates between heating a room and "resting" until the mechanism detects enough of a differential in the room temperature that it goes back into heating (heat + Far Infrared) mode again.
Does the amount of Far Infrared increase with the heat settings?
No. There are two sources of Far Infrared and Negative Ions: the Amethyst & Tourmaline crystals, and electrical generation. The presence of Far Infrared and Negative Ions from the Amethyst and Tourmaline crystals is static. The presence of Far Infrared and Negative Ions from electrical generation only depends on you turning on the BioMat (for Negative Ions) and selecting a heat temperature (for Infrared).
Do the Negative Ions run all the time?
Yes, and no. See the above answer, and this is a reminder that independent of the heat or “On” setting you have chosen, Amethyst and Tourmaline emit Negative Ions naturally, as it is a natural property of those stones.
How does the BioMat compare to FIR Saunas?
- Deeper penetration of 6-8 inches on the BioMat, compared to 2-3 inches in a sauna
- Addition of Negative Ions on the BioMat which neutralize Positive Ions (i.e. free radicals)
- Protection from EMF on the BioMat
- Size – easier to store and move the BioMat
- Cost – BioMat is significantly less expensive